Masonry work on New York City buildings

Masonry is brick, block and stone, and the mortar holding them together. We repair and rebuild it: joints, individual bricks, whole wall sections, facades, the steel lintels over windows, chimneys and the coping on top of a parapet. Almost every job we are called to started as water getting into a wall.

Call (929) 412-6597 Send photos

What we repair

How NYC masonry actually fails

The housing stock here is mostly brick, much of it a century old, and it fails in a pattern you can almost set your watch by.

Water gets into a joint. It freezes, expands, and opens the joint a little wider. The next thaw lets more water in, and the cycle repeats every winter. After enough cycles the mortar is sand, and the water reaches the brick itself. Now the brick freezes wet, and the face pops off — that is spalling, and once it starts you are replacing units rather than joints.

Steel runs through these walls too. The lintels over the windows, and shelf angles in later buildings, are steel sitting inside masonry. Wet steel rusts, and rust takes up more space than the steel it came from, so it pushes the brickwork apart from the inside. The stepped crack you see above a window is usually that, not a settlement crack.

Parapets and chimneys go first in almost every case, because they are exposed on several sides at once with weather above, in front and behind, rather than being protected by the building underneath.

The mortar question

Mortar is meant to be softer than the brick it holds. Movement in the wall is supposed to be absorbed by the joints, which is why old mortar crumbles while old brick survives. Replace that soft mortar with a hard modern cement and the relationship inverts: the brick becomes the weakest element and takes the damage instead.

On the soft brick and brownstone that much of this city is built from, using the wrong mix is not a small mistake. It is the reason some walls look worse five years after they were repointed than they did before. We match the mix to the wall. The detail of how that is done is on the brick pointing page.

Working out what the job really is

Masonry quotes vary wildly because the diagnosis varies, not because the prices do. The same cracked wall can be a pointing job, a lintel job, or a question for an engineer, and those are three different numbers. So the first thing we do is work out which one it is, looking at the whole elevation rather than the patch you noticed.

Then you get it in writing, itemised: the access method, the area, what is included, what is excluded, and what becomes a change order if the wall opens up worse than it looked. If another contractor has already quoted you, that written scope is what lets you compare the two honestly.

Access, permits and neighbours

How we reach the work often costs more than the work. A rear wall at ground level is a ladder job. Four storeys on a street frontage needs a boom lift or pipe staging, and in a tight street that means planning where it stands and when.

Landmarked buildings need Landmarks Preservation Commission approval before exterior masonry work, usually with a mortar sample to match the original. We build that into the programme rather than discovering it once equipment is on site.

What we do not do

We do not quote a wall from the street. We do not point over a failed lintel and call it finished. Where a wall bulges, or where cracks split the brick units themselves instead of following the mortar, we tell you an engineer is needed rather than taking the work. Roofing is handled on our separate roofing sites.

Where we work

The Bronx, Queens, Brooklyn and Manhattan, from the Bronx.

Common questions about masonry repairs

Is the crack in my wall serious

The shape tells you more than the length. A crack that wanders along the mortar joints, stepping around the bricks, is usually weathering or minor movement, and it is a repair job. A crack that runs straight through the brick units themselves, or one that is wider at one end than the other, suggests the wall is moving, and that deserves an engineer’s opinion first. A crack that has visibly opened further over a few months is the one to act on regardless of its shape.

Why is only one wall of my building falling apart

Exposure. The elevation that takes wind-driven rain, usually facing south or west here, goes through far more wet-and-freeze cycles than a sheltered one. Rear walls fail early for a different reason: nobody looks at them, so small problems run for years. And anything with weather on more than one face, such as a parapet or a chimney, ages faster than the wall below it.

Do I need a permit for masonry repairs

Ordinary repointing and brick repair on a private house generally does not need a Department of Buildings permit, though the equipment used to reach it can. A landmarked building is different: exterior masonry work there needs Landmarks Preservation Commission approval first, and the Commission may want a mortar sample. We tell you which applies to your building before anything is scheduled.

How long should masonry repairs last

Good repointing in a mortar suited to the wall should be measured in decades. The honest caveat is that masonry is a system: new joints in a wall that is still being soaked from a failed parapet or a blocked downspout will not get their full life. Fixing the source of the water is part of the job, not an upsell.

Get the wall looked at

Photographs help: one from across the street, one close enough to see the joints. Call (929) 412-6597 or use the estimate form. Our licence and insurance details are on the credentials page.