Stucco repair and installation
Stucco is a cement render applied over masonry or over lath. Done well it is a hard-wearing finish that sheds water and lasts decades. Its weakness is that it is a skin: once water gets behind it, the water cannot easily get out again, and the damage happens where you cannot see it until a patch sounds hollow or falls off.
- NYC DCWP licensed
- Repairs and full elevations
- Free written estimate
Call (929) 412-6597 Send photos of the wall
What is going wrong with your stucco
- Hairline cracks all over, often in a map pattern. Usually shrinkage, cosmetic at first, but every crack is a way in for water.
- A single straight crack running through, often from the corner of a window. That follows movement behind the render, not the render itself.
- Hollow areas. Tap the wall: a drummy sound means the stucco has debonded from what it was applied to. It is no longer attached, whatever it looks like.
- Bulging or blown sections, where the render has come away and is being held on by its neighbours.
- Rust stains, meaning the metal lath or a fixing behind the render is corroding.
- Staining in a band near the bottom of the wall, where water running down behind the stucco finally exits.
- Previous patches that stand out in colour or texture, which usually means the last repair fixed the hole and not the cause.
Why patching alone often fails
The common repair is to cut out the loose piece, fill it, and paint over. If water is getting behind the render somewhere above the patch, the patch will debond in the same way the original did, because nothing about the cause changed.
So before cutting anything we work out how water is getting behind: a split at a parapet or coping, a sill that has lost its slope, a failed joint around a window, a downspout that has been discharging against the wall for years. Fixing that first is what makes the stucco repair last.
How we repair it
- Sound the wall by tapping to map every hollow area, not just the part that is visibly damaged. Debonded stucco usually covers more than it looks.
- Cut the failed render back to a sound edge. A ragged feathered edge is where the next failure starts.
- Deal with what is behind it: repair the masonry, replace corroded lath, and close the route the water was taking.
- Rebuild in coats, allowing each to set rather than rushing the next, and match the texture of the surrounding wall.
- Finish or coat the repaired area so it weathers with the rest of the elevation.
Stucco over brick, and when not to
Rendering over tired brickwork is a common request, because it is cheaper than repointing a whole elevation and it looks new immediately. Sometimes it is a reasonable choice. Often it is a way of sealing a wet wall shut.
If the brick underneath is saturated or the joints have failed badly, a cement render traps that moisture rather than curing it, and the problem continues out of sight until the render debonds or the brick behind spalls. We will say so. If the honest answer is that the wall needs pointing rather than covering, that is what we will quote. See brick pointing.
Coatings
A sound stucco wall is usually finished with a masonry coating rather than ordinary paint, because the coating has to keep rain out without sealing the wall completely shut. Thorocoat is the product most often asked for here, and how it behaves — including what it will and will not bridge — is on the Thorocoat page.
What changes the price
- How much is debonded, which is usually more than the visible damage.
- Access, as always. A rear wall off a ladder is not four storeys with a lift.
- Whether there is a cause to fix behind the render.
- Matching an existing texture, which takes longer than a plain finish.
- Patch or whole elevation. Patches are cheaper but show; a full coat evens the wall out.
[OWNER TO CONFIRM: masonry warranty]
Questions about stucco
Can you match my existing stucco texture
Texture, usually yes. Colour, not exactly, because the existing wall has weathered. On a visible elevation most owners end up coating the whole face so the repair disappears, and we will price both options so you can choose rather than be surprised by the result.
Is the cracking serious
Fine map cracking across a panel is normally shrinkage and is a maintenance matter. A single crack running in one direction, especially from a window corner or across a whole storey, is telling you something behind the render is moving, and that needs looking at before the surface is made good.
How long should stucco last
Decades, when it was applied over a sound and dry substrate and water is kept off the top of it. Stucco rarely dies of old age in this city. It fails early because something above it — a coping, a sill, a downspout — has been putting water behind it.
Where we do this work
The Bronx, Queens, Brooklyn and Manhattan. Much of it is on attached and semi-detached houses and two-family buildings, where rendered fronts and rear elevations are common.
Get the wall looked at
Photographs of the whole elevation plus a close-up of the damage are enough to start with. Call (929) 412-6597 or use the estimate form.